|
Electrical remote control air and sand separated blast machine
This electrical remote control blast machine system consists of pneumatic inlet valve, exhaust valve, pneumatic abrasive valve and control system, operation switch. The operation switch has three gears, the first switch is to close, the second switch is to open the air, the third switch is to open the sand. When closing, close the sand before close the wind. When the switch is at the second gear, open the inlet valve and close the exhaust valve, the sandblast cylinder is in a pressure maintaining state, while the spray gun blows air. When the switch is at the third gear, the abrasive valve opens and sandblast working starts. The good point of blowing air before sand is that sand blowing will be steady and fluent, without impulse phenomenon. When closing, closing the sand first will make the residual sand cleaned in without sediment, blowing the air alone will be ash-cleaning.
Double-silo continuous sand adding high-efficiency pressure sandblaster
Double-silo continuous sand adding high-efficiency pressure sandblaster is a double-silo structure, thus it can meet continuous working requirement, the sandblast work will be successive, no need to stop the machine and add the sand, which increases sandblast efficiency greatly.
ACMR-6W-4A large-sized ship four-gun pneumatic remote control pressure high-efficiency sandblaster
Technical parameters: drum parameter：Φ1640mm；height：2400mm； volume：3m3 ； spray gun qty：4； steel shots one load：10T； copper ore one load：3.5T；
|